Forged Steel Y Water Meter Strainer Working For 800lbs , Trim 13CR NPT / SW A105

Forged Steel Y Water Meter Strainer Working For 800lbs , Trim 13CR NPT / SW A105

Mail part & material

Body: A105

Filter: stainless steel

O-ring: NBR

Brief introduction:

The strainer may be used on all types of pipelines to collect granulated foreign substances and 

contaminants collected. It can improve the clearance in the medium, and prolong the life of valves 

and other equipments. It is suitable for wafer, petroleum and steam.

Mail part & material 

Body: gray cast iron, cast iron, ductile iron 

Filter: stainless steel 

O-ring: NBR 

Technical Specification

- Nominal diameter:65～500mm        

- Nominal pressure:1.0/1.6/2.5Mpa

FEATURES
•  Iron strainers are complete with Flat Face (Series 125YF) or Raised Face (Series 250YF)
    flanges in accordance with ASME B16.1.

•  Strainer body meets applicable ASME Standard.

•  One piece cast body.

•  Strainers equipped with bolted cover flange that utilize a flat gasket seal.

•  Low pressure drop.

•  Upper and lower machined seats.

•  304 SS perforated screens are standard.

•  Drain/Blow-off connection furnished with plug as standard.

•  Generous screen area and properly proportioned straining chamber to minimize initial pressure

    drop while maximizing time between cleanings.

•  Compact end to end dimension.

STRAINER INSTALLATION INSTRUCTIONS
A . Ensure all machined surfaces are free of defects and that the inside of the
strainer is free of foreign objects.
B .  For horizontal pipelines, the strainer should be installed so that the drain
connection is pointed downwards.
C .  For flanged end strainers, the flange bolting should be tightened gradually in
a back and forth clockwise motion.
D .  Once installed, increase line pressure gradually and check for leakage around joints
E .  If the strainer is supplied with a start-up screen, monitor pressure drop carefully.